Pipefitter licensing in Wyoming

Wyoming has no state fitter license — the statute book licenses nothing mechanical — and much of the state's industrial work sits OUTSIDE any city's permit jurisdiction entirely, where no worker card applies at all. Inside the cities: Casper licenses individual trades and by ordinance accepts an equivalent license from another WYOMING jurisdiction (in-state portability only — never interstate reciprocity); Cheyenne's licensing pages wall off automated readers, so get its class list by phone.

City-dependent and not established. Sites outside city permit jurisdiction may have no card requirement at all — confirm per site rather than assuming either way.

Per-city mechanical exams under each regime's rules (Casper's machinery is mapped; class-specific standards from the city). The two questions that decide every Wyoming placement: which city pulls the permit — and is the site inside city jurisdiction at all?

Per-city hour-banking toward the local exams; registered apprenticeship in parallel. No state tier exists.

THE WHOLE ANSWER LIVES HERE — where it exists at all: Casper mapped (individual licenses + the intra-Wyoming acceptance rule); Cheyenne unread behind its bot wall (call them); the smaller cities unchecked; and the energy-sector sites outside city limits commonly need no worker card.

Company licensing is municipal where it exists. Verify the employer with the city holding the permit — or establish that no city holds it, which on Wyoming industrial sites is often the real answer.